on 02-20-2013 9:06 PM
We are using the following scenario:
03 inspection type with inspection points 100
Sampling procedure has got valuation mode 700 - mean value
within tolerance limits
When we record results for 2 or 3 inspection points with some
of the results out of spec and then go to make UD, in the list of chars
relevant for UD the system summarizes recorded values. If a test result from
the last insp point is out of spec, then it is displayed in the list. If the
test result is in spec in the last insp point, then char is not listed, even
though there was a result out of spec recorded in one of the insp points.
For example, test A with lower limit 1 and upper limit 10
Insp point 1 test result = 9
Insp point 2 test result = 15
Insp point 3 test result = 9
In UD screen, test A is not listed as char relevant for UD,
even though for insp point 2 result is out of spec. And the average of all
three insp points is also out of spec.
What the business would like to see is that if a single
result is recorded out of spec for any of the insp points, then the char should
be displayed in chars relevant for UD with a red cross next to it.
Does anybody know what drives SAP logic to look at the last
insp point during UD? And can it be changed through config?
Thanks in advance
You should also review this thread very carefully. I believe you might find it helpful.
http://www.sapfans.com/forums/viewtopic.php?f=27&t=360976
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
In configuration, for the inspection point identifier at the bottom of the screen is a field:
"No. insp. points for char. summariz."
Make sure that has a number larger than the number of inspection points you expect.
Below that is a check box. "Last inspected sample is valid". Make sure this is NOT checked.
I suggest you read the help file available for each of these fields.
Lastly, make sure each of your inspection points is valuated and closed.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
7 | |
7 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.