on 02-21-2013 6:10 AM
Dear all,
I have created a sampling scheme for Dependent multipe samples in QDP1 as given below
valuation parameters- Attributive inspection
Inspection severity - Normal inspection
I have assigned the C1- Acceptance level , D1- Rejection level upto C7; D7 values, Lot size and corresponding sample size values in sampling scheme
Sampling procedure is created without inspection points
I have assigned the sampling scheme in sampling procedure
When processing the Results recording for the inspection lot, The next succesive samples are not considered
For example:
For the sample 1
Inspection lot qty - 15
sample size - 3
Acceptance level- C1- 1
Rejectance level - D1- 2
If 2 characterstics in the inspection lot is rejected means the whole inspection lot will get rejected, if 1 characterstics is rejected means, inspection lot is accepted and next sample with acceptance C2 and rejectance level D2 will be displayed. In my case, 2nd sample is not appearing, the first sample is getting closed with accepted, if i click the icon "Valuate", even though i have rejected 1 characterstics in the inspection lot, next samples is not getting opened.
Where should i check and configure?
Kindly clear the issue3
.23
J.Balakrishnan
Acceptance level- C1- 1
Rejectance level - D1- 3
Input result 2, then system will ask you "valuate" or "new sample" because system cannot valuate it.
Regards, DoWook KIM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.