Packages not showing in SAINT

[Former Member]

Greetings,

I have just installed a dual-stack NW7 system and would like to install the GRC 10.0 add-on.  I used sapcar -xvf to extract the GRC .SAR files and placed them into \usr\sap\trans\EPS\in directory and executed t-code SAINT.  I then went to Load and it recognized all the packages in the \EPS\in folder.  However, when I push the <back> button, there is an empty list with the message "No fitting Installation Packages are available".

Can anyone advise why my packages are not showing up in SAINT?

Thanks

[former_member185239 · Accepted solution]

Hi Bartz,

You will not able to see the support package in SAINT transaction

1. You have downloaded the version of GRC 10.0 which is not compatible to

    SAP_BASIS and SAP_BW

SAP Note 1490996: Inst/Upgrade GRCFND_A V1000 on NW7.02

Enhancement Pack

2. Or check the filter button in SAINT transaction.

With Regards

Ashutosh Chaturvedi

[Former Member]

Hi All,

Apologies for the late reply (somehow the responses were not pushed to my e-mail).  This was a silly mistake on my part that the packages were not compatible with my version of NW7.  Once I obtained the correct packages, I was able to see them in SAINT.

Thank you all for your prompt and helpful responses.

[Former Member]

Hi Bartz,

You can check the compatibility of the add-on component in service.sap.com/pam.

As I see in PAM, for Netweaver 7.0 the below Add-ons are supported.

SAP GRC ACCESS CONTROL 5.3

SAP GRC Access Control 5.3

SAP GRC PROCESS CONTR. 2.5_7.0

SAP GRC Process Control 2.5

SAP GRC RISK MANAGEMENT 2.0

SAP GRC Risk Management 2.0

Can you load the supported Add-on and try again.

Hope it helps.

Regards,

Mudasir.

[Former Member]

Hi,

Can you please share your Component version , i mean support package of your system.

What is the package of GRC 10.o you are using??

Thanks and Regards,

Vimal

[Former Member]

Hi

Please confirm whether that GRC patches are related to your version or not.

Mahipal