on 02-16-2013 10:43 AM
Hello All ,
I am facing a very strange kind of issue. I created a simple SOAP to SOAP scenario .Intially i did the usual configuration i.e creating RD, ID,SA,RD etc where the msg is processed thru the Integration engine. Now whn I posted a SOAP message Iit worked fine . But since there was no complex processing ( like multi mapping etc) i changed the configuration to Integrated Configuration to by pass the IE.
Now when I post the same message from the SOAP UI ( to the same end point) .The message is received by the Sender communication channel but the SOAP body is blank i.e its not reading the <SOAP body > element. SHOWN BELOW . I have not changed any configuration for the SOAP channel while switching to Integrated configuration .
<SOAP Body > in the received message in sender CC
Thus the sender channel shows the following error msg in RWD -
Note that the SOAP body in the posted message is not blank.It has a few elements
Kindly share any idea as I am totally stuck here. Your help will be much appreciated.
Can you verify your sender URL
http://help.sap.com/saphelp_nwpi71/helpdata/EN/fc/5ad93f130f9215e10000000a155106/frameset.htm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
Your sender is an SAP system? Can you share a screenshot of your sender CC ?
Regards,
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rahul,
please check the service generated in Service registry.
Service Registry--> search in Service Definitions--> end point
Else generate service again from ID and then run the interface.
Regards,
prasanth
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.