SNP

[Former Member]

Hello Everybody

Can you please tell me why am i not able to see the Source location  (i see the cource location empty ) on the SNP Preq generated on the DC (ATP Category AG).

I checked the where use list ...it has only one source of supply, but i dont see any distribution demand planned (BH) on it??

Regards

Rachel

[sourabh_jain66 · Accepted solution]

Hi Rachel,

TLane is the reason for this type of issue, if you don't have a TLane and have a procurement type 'F' set at your DC, then system SNP will create PReq but will be unable to decide on sourcing location in absence of TLane.

Please create TLane and then you should have source location in your PReq.

Please let me know for any further issue you experienced in this.

Rgds

Sourabh

[Former Member · Accepted solution]

It was the Low Level Code....once i ran that...i was able to see the Source...Thanks!

[rajkj · Accepted solution]

Good point. Thanks for sharing the information.

[rajkj]

Hi Rachel,

Have you created a transportation lane between your source and destination locations? For an external procured product at DC, SNP creates PReq by default. If there is no t.lane, the source of supply will be empty.

If you have not yet created a t.lane, create one and run the heuristics again so that generated PReq will have a valid source of supply.

Thanks,
Rajesh