Error in Transport Individual Objetcs with ICO in PI 7.3

[former_member201264]

Hi Experts,

I have already my scenario in QA and got some error while testng in QA. So now I changed my ICO in the same DEV scenario.

While Moving Integrated configuration from DEV to QA, I am getting the following ERROR.

"Could not fully load object because the following communication channels could not be loaded"

I have  done CTS+ with individual Objects by taking only ICO.

Our Basis team imported successfully. But when I check in the imported objects I can see but with the above error.

Is it necessary to move CC Sender and CC Receiver along with ICO?

OR any  other idea?

Regards,

Sree

[Former Member]

Hi,

Compare your objects in Dev and in QA...

Check whether all the objects of the ICO used in Dev are imported to QA ?

Check whether you have used new CC as part of your changes and which has not included in your change list...

HTH

Rajesh

[anand_shankar10]

Hi Kancham,

When the error is about the loading of Comm Channels then better try transporting the channels only. Why the ICO object only?? Just a suggestion...

Thanks

Anand

[former_member201264]

Hi Anand,

I did not assing SWCV of Sender Interface in the Inbound processing tab of ICO.

It is working fine in DEV but in QA geeting error as Sender Aggrement not found.

So i corrected and moved to QA but no luck error only.

Is this the issue?

Regards,

Sreeni.

[anand_shankar10]

In that case bear a little more pain and do a fresh transport.

BTW if the same config was working in DEV it should not make any difference in QA.

Good Luck..

Regards

Anand

[Former Member]

Hi Sreeni,

Please check the business systems used in ID and SLD transport tab.

Also please check any existing inactive transported objects in Change list.

Regards,

Prasanth.