RE: Units of different dimensions cannot be converted

[Former Member]

hi

i got error in sap ps cn41n

Units of different dimensions cannot be converted

and i cheking in cj20n under network no material components. Plz. provide solution

thks

apr

[Former Member · Accepted solution]

Hello Prasad,

Please check if there was any change of unit has been done in activities after partial confirmation has been done. When confirmation has been done in new unit, this error can come.

You can try not to confirm this activity and delete that activity. Subsequently save the network and attach new activity again and then can confirm activity.

Try this scenario in test system and check if you are still facing same error.

Regards

Tushar

[Former Member]

Hi,

Can you let me know  what you are doing in CN41N so generated error.

Regards,

Sudhakar

[Former Member]

hi ,

cj20n level deleted material component  and activity and unconfirmed the network then deleted the operation system not allowed.

pl see below i run report cn41n

kindly help me

thk&rd

prasad

[MohanDesai]

Hi Prasad,

Already Tushar has given some points. If you can share the screen shot of your Activities created it can be useful in resolving this issue.

Regards,

MRD

[Former Member]

Hi,

i checking prod server wbs element releated PR 'S

1.all PR released

2. PO released> migo > miro> material doc transactions completed

i created under wbs element new n/w>activity> material component>network released > save

same error getting

kindly suggest me process

>cn41n

[Former Member]

Hi,

With your posting absolutely cluelss and does not make sense. Sorry about that.

Go back to CJ20N and create a new network activity and check for default UoM and compare with other activities which are already in the project. If you notice mismatch please change it.

Then go to tac-OPUU (Maintain network profiles) on the tab Activities check what UoM was maintained there. Hope you must be using internal activity with control key PS01 (ZS01) whatever you might have done customization.

Message was edited by: Sudhakar Pappu

[Former Member]

Hi,

opuu

internal activity

activity tab under we are maintain below see

control key ps01

unit for work= day

normal dur unit =day

cal key =2(cal.work

service activity

control key=ps04

cost element=45252

m.group=service

uom=au

kindly suggest me if config required i am asking one question

why it is getting error in cn41n report

Units of different dimensions cannot be converted

ts error only one project remaining all project working fine cn41n

thks& rds

prasad

[Former Member]

Hi,

Go back to PB and check what was default UoM in that particular activity. Other than "day" delete manually and input "day".

Create another activity and check for default UoM.

Regards,

Sudhakar

[Former Member]

Hi,

i Create another activity and check for default UoM.=day.I am facing problem only single wbs element &network ts network PR>PO>MIGO already posted material doc.

cn41n report same error error

kindly suggest me  steps wise

BR

PRASAD

[former_member228466]

Dear Prasad,

Apparently someone changed the units of the operation after it was partially confirmed . When they confirmed in the new unit the error started.

unconfirmed the network, then deleted the operation and saved. After that just created the operation again and confirmed the network.

Regards

Soni

[former_member228466]

Dear Prasad,

Also check what is the UOM maintained for activity type.

Regards

Soni