Copy inspection results from one lot to other

[former_member214626]

Hi Friends ,

I am trying to copy inspection results from one lot to other . But it is not happening . I have tried following :

1. Done settings in SPRO  under setings for copying  inspection results for inspection type 01 and 15 with options :

    control in inspection lot = manual start of data transfer .

   control in RR = manual start of data transfer

   origin TL = 02

   Dataorigin RR = 02 .

In MIc , I have maitned , origin results data = prev inspection lot .

Now while doing RR in QA32 , after selecting the physical sample no when I am entering the RR screen and going to Edit-> Copy inspeciton results . There is no such option also in check in Qa02 . But its not there also .

Can any body help (using ECC 6.0 )

Regards

[former_member42743 · Accepted solution]

Have you tried mapping 200?

FF

[former_member214626 · Accepted solution]

I tried with mapping 200 then it works . But I am facing another issue in same so have opened a new thread .

many thnx

[Former Member]

More or less try to change the settings in

SPRO>IMG>QM>Quality Inspection>Make Settings for Inspection Results

And refer document

[Removed by moderator.]

[former_member214626]

Hi sjit ,

I ave already done the settings and also mentioned the same in my question but stil its not happening .

The link mentioned by you doesn't exist .

[former_member214626]

Hi friends ,

in my ides : i m getting the option for copy isnpection results . but even after using the option its not copying the results from the lot which is selected . Please find the attached scren shots :

activated this for inspection type 01 :

in RR on using Edit-> copy inspection results :

[Former Member]

What is status of the previous Inspection lot from which you are copying the result.?

I hope its UD ICCO or INSP etc.

In short RR is already done for that lot.

[former_member214626]

Hi Sujit ,

Yes status of previous lot from which i want to copy RR is " INSP RREC SPRQ "

Regards

[Former Member]

did you manage to get,

Extras ® Display Transfer Log if any.

Socond thing to check is make sure that BAdIs QEC_RESULT_COPY QEC_SELECTION and 

QEC_MAPPING are implemented on your system.

Check on cegain by taking UD os existing lot(previous lot)

if this also in place then I am sure customization made is not correct.

[former_member214626]

Hi Sujit ,

Thanx a lot for your help . Yes the mentioned BADI's are there . I also checked the log . Log says :

"Data selection procedure 300 could not find any data " .

I think I should check with ABAPer . May be some data is not getting selected thats why its not copying it .

Whats do you think ?

REgards

[Former Member]

Yes...Debug it !

[former_member214626]

Hi Sujit ,

I have checked the transfer log . Following error is displayed :

In my inspection plan for all the MIC , I have selected origin = from previous lot

[Former Member]

I hope result of source Inspection char is done & status is "5" also enough result are recorded as per sample size.

also check the source and destination MIC's are same with same control indicator & sample size.

[former_member214626]

Hi sujit ,

For source the status is 5 . Also the MIC is same because my material is same in both the inspection lots . So MIC are copied from same inspection plan . Still its showing me same error msg .

Source lot :

Destination lot :

Please help .

[former_member214626]

Still waiting ... nybody know the solution ?

[former_member214626]

any help ?