on 01-16-2013 5:30 PM
Hi All
We installed a fresh SCM 7.0 EhP1 system with SPS_03 for the SCM GATP RDS.
We found that we need to install 3 Add-On components namely BP-SOLBLD (Solution Builder), BP-SCM and BP-CANW 702V6 for the RDS.
The dependencies were the upgrade of the Support Packages like SAP_BASIS, SAP_ABAP, SCM components and SAP_BICONT.
The SAP_BICONTENT in particulat required a SP delta upgrade from 70503 to 70604 which was done successfully.
The equivalence levels for the SCM components showed the following-
1. BI-CONT 705
as well as
2. BI-CONT 706.
There was a green mark on the 706 but the 705 has gone into red.
This means we need both components to be existing simultaneously on the system for us to continue with the update of the SCM components.
HAS ANY ONE actually seen such a problem occur when update of the SP is happening?
We are unable to get past this stage as this is one of the dependencies for the SCM SP update in the SPAM transaction.
Thanks
K.Phanindra.
Hi,
It seems that one of the pre-requeistie support pack is not installed.
Please go to system -> status -> component information (Under system data) - > you can see the list of support packs in there -> click on print.- Spool request will be created. Go to sp01 and get the spool request that is created. Click on print and attach the list of support packs details here.
As well as please in your screenshot , can you please expand show us what is the support pack that is missing . We cant see the full name of the support pack which is under BI-CONT 705
As well as please check the below two notes .that will explain you in details what are the other support packs that are necessary.
What is your current SUPPORT pack level ????
Note 1594104 - BI_CONT 706:Information on Add-On Support Packages = EXPLAINS YOUR ISSUE YOU CAN SEE THE LIST OF SUPPORT PACKS THAT ARE NECESSARY TO INSTALL BI_CONT 706.
Note 1558363 - BI_CONT 7.06: Information about installation and upgrade
Thanks and Regards,
Vimal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Phanindra,
From the attached screenshot I could see that system is providing 2 options for matching the pre-requisities in the form of equivalance level 1 and equivalence level 2. You need to match either of these prerequisite sets to continue with the path.
There could be some other patch requirement which might be stopping you . Please check in detail again.
Regards,
Deepak Kori
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.