abap/heap_area_total

[teddylv_andersen2]

Dear Forum,

Can abap/heap_area_total be set higher than the max specified in RZ11 (2.147.483.647)?

Best regards,

Teddy

[christian_bartels · Accepted solution]

Up to SAP release 4.5B, abap/heap_area_total was limited to a 32-bit signed integer (representing 2 GB - 1). This limitation has been removed in SAP release 4.6 (see SAP Note 180872).

Kind regards,

Christian Bartels.

[Former Member · Accepted solution]

Hi Christian,

this is unfortunately only partly true ...

Note 548845 - Internal modes uses more than 2 GB

=> as of 6.40 and in most 6.20 systems everything should be OK - but in 4.6C there this will not properly work because of SYSTEM_IMODE_TOO_LARGE ...

"... You cannot avoid this error by changing memory profile parameters such as ztta/roll_extension and abap/heap_area_nodia."

In 4.6C it can be done up to 4GB - but just without full SAP support ...

Regards

Volker Gueldenpfennig, consolut.gmbh

http://www.consolut.de - http://www.4soi.de - http://www.easymarketplace.de