Round function causes large difference when copying from Infocube into Planning Area

[Former Member]

Dear SAP Gurus,

I have one problem needing your help:

In infocube, some data item are:

Item 1: 20,50

Item 2: 30,50

Total: 51,00

However when use tcode /sapapo/tscube to copy data from Infocube into Planning Area, I check data of Key Figures in Planning Area and find that:

Item 1: 21,00

Item 2: 31,00

Total: 52,00

That means: when copying into planning area, data is rounded up with each item. Then total value is different. When I have more Items, let says 1000 Items, the difference is too large and not acceptable.

How and where can I configure so that in Planning Area, data keep the same value for each Item as in Info cube?

Thanks very much for your help!

Duyennx.

[Former Member · Accepted solution]

Hello,

Could you please check the settings maintained in

TA : /sapapo/msdp_admin

Open your planning area and check 'Decimal Places' column settings under  Key figure tab

Additionally you can also refer to SAP Note 389760.

Hope this helps you.

Regards,

Anurag

[Former Member · Accepted solution]

Dear Mr. Anurag Tiwari,

Thanks very much for your helpful support.

Best Regards,

Duyennx