on 01-03-2013 10:33 AM
Dear
In material master I have assigned inspection type 04.I created a order,confirm & 101 gr posting.After that I have received a inspection lot no with release status.
At the time of result recording system through an error Message no. QE181 .
( Characteristic results cannot be recorded for inspection lot 040000004080
Message no. QE181
You cannot record any characteristic results for this inspection lot. The material master has been set up for the existing inspection type in such a way that results recording is not supported.
Confirm defects for this inspection lot or select another inspection lot in which you can confirm the characteristic results.)
After that I made a changes in QP02 & inside assign the inspection characteristics.Then I created new order for that inspection lot system is taking result recording.
But my question is that-before I was assigned inspection characteristics, I have already 10 nos of inspection lot is there for result recording.For this system is not taking RR.
please tell me how to do this part.
Thx
ALLY
Hi Ally ,
For those lots go to QA02 select the lot and then go to "insp specificaiton" tab over there manuall assign inspecion plan then it will be released. save lot. then go to qa 32 for RR
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
1. go to MIC (QS23) , under control indicators tab tick the sampling procedure check box .
2. Now , go to QP02 , select the operation go to MIC list then reassign the MIC which is updated in above step . Against this MIC enter the sampling procedure . Save .
If you wan to create Sampling procdure :
1. Go to QDV1
2. Enter decription
3. Sample type "fixed"
4valuation "manual"
5. Go to next screen
6 . Clcik sample tab and then enter sample size say 2 .
save
REgards
User | Count |
---|---|
91 | |
10 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.