on 01-02-2013 1:11 PM
I am trying to eleiminate red and yellow signals from CJVC for statistical key figure assignments but for the value categories for aggregated POC and POC for RA it is shown in red. When I see the configurations I see these are maintained as SKF with total values.ANd no cost elements assigned in OPI2.
However all of these 5 SKF are assigned to 5 different VC. Again when I see config for Statistical key figure for POC I find only SKF "10" is defined for Non aggregated POC for this CO Area and when I am trying to maintain new entries for Aggregated POC with SKF 20 system throws error: "Statistical key fig is incorrectly defined". Same happens when I am trying to define SKF "30" with usage POC for result analysis.
How to eliminate the these errors?
Hello Suman,
Could you check this post ? it is possible it can be useful http://scn.sap.com/message/8583705
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.