IDoc Acknowledge from PI by using ALEAUD

[Former Member]

Dear Expert,

     I have some problem about IDoc acknowledge from PI to SAP R/3 4.7.

     My scenario is IDoc to File from SAP R/3 4.7 to third's party and I config "Integration Builder" SAP PI as below detail :

          - BS_XX : Business system of SAP R/3 (maintain in SLD, Technical system)

          - BC_XX : Business component of Third party (dose not maintain in SLD and Technical system)

          - CC_File : Communition channal for file server    

          - Ack_CC_Idoc : Communication channel for acknowledge

          - Receiver agreement : Does not config header mapping

          - Receiver Determination : No routing rule

          - Interface Determination : No condition of operation mapping

     and already config RFC destination, port, partner profile, idx1, idx2, IDX_NOALE in PI following this document :

          - http://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/e07dcaa0-a92b-2a10-3a96-b3d942bd1...

          - http://scn.sap.com/message/8554207

          - http://wiki.sdn.sap.com/wiki/display/ABAP/HandlingIdocAcknowledgements

     Or other link that have been post in this forum but we still have problem following below detail :

          - PI dose not send "ALEAUD" to SAP R/3

          - IDoc acknowledge message has error "Unable to convert the sender service BC_XX to an ALE logical system"

          - Acknowledge Status is "Acknowledge is possible"

    Please help to inform me what important point that i missing.

    Thank you for your advice!!!

[Former Member · Accepted solution]

Hi,

Add the logical system name in the ECC Business System->Communication Component->Adapter Specific Identifier.

Thanks

Satish.

[former_member188961]

Hi,

We have done the similar requirement in our project.

To send the IDoc Acknowledgment from PI to SAP R3 system. you need to map the Control Record of your IDoc to ALEAUD Idoc in PI and add the mapping in the Interface determination as shown below.

Once the IDoc is came to PI then the control record of that IDoc will map to ALEAUD and it will send Ack Idoc to SAP R3

Hope this help you.

Thanks,

Srikanth