on 12-17-2012 5:58 PM
Hello
We are introducing automatic defect functionality in case of
characteristics failure during result recording, however we are getting
double defect record even if one characteristics is failed.
We are using inspection point set up and doing result recording and
valuation at inspection point.
Please refer attached document for further details
I came across SAP Note 328956 which describes almost similar nature of
issue, however we are using valuation rule "10" and FM associated with
that valuation rule is different than mentioned
Any suggestion on this topic would be appreciated and will be helpful
Regards
Yogesh
+44 7405898531
Hi,
Attachment missing
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please refer Note 328956 - Influencing automatic defect data record with inspection point
This will solve your issue.
Even if you use different valuation mode in sampling procedure, the valuation rules A3, A4, A5 are relevant for valuating the summarized inspection
results for the inspection points.
You must replace the function modules stored in the valuation rules A3, A4, A5.
Regards, DoWook KIM
Hi Do Wook
Thanks for the reply. The only concern is valuation rule.
The valuation mode which I am using in sampling procedure is related with valuation rule 10 and function module is different than A3, A4 and A5 and this OSS note mentions only about these three valuation rules.
Will it be applicable for valuation rule 10 also
Regards
Yogesh
+44 7405898531
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.