Virsa predefined rule sets are missing

[Former Member]

we have COMPLIANCE CAL. 4.0_700 on ECC 6.20. During initial installation we missed to load standard rule set provide by SAP. How can I find predefined rule set and upload them to virsa?

[Former Member]

Hello Friends,

I found SAPK-40111INVIRSANH which have VIRCC folder in this folder there a file CC_Rules.Zip. How can i confirm this complete pre-delivered rule set? If this is complete rule set then where should I save it before i run the rule architect wizard?

Your kind suggestion and help would be deeply appreciated!!!!

[neerajmanocha]

Hi Arvind,

In 4.0 Compliance Calibrator, rules were delivered via BC Sets. These BC Sets start from keyword...

/VIRSA/CCRULES...... & /VIRSA/CCRULESTEXT......

So if you need standard rules delivered by SAP for 4.0, you can activate the BC set delivered as latest with support pack installed.

Note:- Activating BC Set will replace all the existing rules data (standard + custom). So if you have done any customizations in rules, you can note it down and then activate the BC Set.

Hope this helps.

Thanks & Regards

Neeraj