Code not appearing

[former_member385587]

Hi ,

An inspection lot was created with 3 qualitative characteristics and 2 quantitative characteristics . But during results recording for the qualitative characteristics does not shows any value for the code . A qualitative attribute selected set was assigned to the MICs and the MICs is defined as reference characteristics model .

But when the characteritics is marked as complete copy model or in-complete copy model and the qualitative attribute selected set asssigned in the inspection plan after which a new inspection lot is created . Fot this incpection lot , the attributive code appears during results recording .

But the client requirement is to have reference characteristics . Please advice.

[former_member184536]

  Please check the mic. and make sure that while creating you have ticked char attribute option.

Manish

[Former Member]

Its unusual ,Check the date & version of reference MIC.

Also check does it reflect in the task list.

[former_member385587]

Thanks for the advices . The master data is maintained properly and the MICs are updated with the correct version in the inspection plan . And the char attribute is selected in the control indicators for the MICs.