on 11-19-2012 12:05 PM
Hi experts.
It was made Goods Receipt Inspection lot.
But, Inspection characteristics were missing for Inspect with Material Specification(QS61).
So, first T-code: QAC3 was running reset sample.
After check 'Insp. with mat spec' in MM02 and Material Specification assign and save in QS61.
Last T-code: QA02 'Task list/spec.' button pushed in 'Insp.Specifications' tab.
'Insp. with mat spec.' checkbox was not checked.
What problem?? How to check it??
If i'm following what you are doing, you are trying to fix an exisitng inspection. Once that inspection lot has been created, changes to the inspection type settings in the material master will not affect it. The lot is what it is. It is a lot that can only be inspected with an inspection plan.
Any NEW lots should reflect the correction you have made in the material master.
For the exisiting lot you should create a one-time use plan to inspect it as desired. Assign it and update the lot with it. Once the lot is in RELstatus you can go and block the inspection plan and remove the material assignment from it so it doesn't mess up any future lots.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
u need to assign at Inspection type level in configuration in QM.
regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI
Check inspection type 01 in Material code whether insp with mat spec is selected.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
'insp with mat spec' was not selected. So, material specification characteristics that are not assigned, Goods Receipt Inspection lot was made.
************************************************************************************************
First, T-code: QAC3 is running for reset sample.
Second, 'insp with mat spec' is selected about inspection type 01 in T-code: MM02.
And Material Specification characteristics is assigned in T-code: QS61.
Last, 'Task list/spec.' button is pushed in T-code: QA02.
************************************************************************************************
But 'insp with mat spec' is not selected Automatically.(Look at red box in Capture image)
How to assign material specification characteristics in Inspection lot?
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.