Where to set the Roadmap steps in the FPM_GAF_COMPONENT?

[Former Member]

Where do I find the Roadmap steps in the FPM_GAF_COMPONENT?

[m_aravindan · Accepted solution]

Hi Kim,

                 Check this following Link , Which describes about step by step usage of FPM_GAF_component.

http://saptechnical.com/Tutorials/WebDynproABAP/FloorPlanManager/Index.htm

Regards

Aravnd

[Former Member · Accepted solution]

hi

[Former Member · Accepted solution]

Hi Aravind

Thank you for the link which explains a lot but

when I reach Pkt. 16 Create/Change Configuration I got this error: ???

Service cannot be reached   What has happened? URL call was terminated because the corresponding service is not available.

Note The termination occurred in system with error code 403 and for the reason Forbidden.

What can I do? Please select a valid URL.    HTTP 403 - Forbidden   Your SAP Internet Communication Framework Team

Strange ???

Best regards

Kim

[m_aravindan · Accepted solution]

Hi Kim ,

              Check this below thread , Which explains exactly about the error  that you are facing

http://scn.sap.com/thread/1002344

http://scn.sap.com/thread/1502981

Regards

Arvnd.

[Former Member · Accepted solution]

Hi Aravind

I fixed the Service error now.

But I get lost at Pkt. 19 where:

The following screen is displayed under “FPM_GAF_COMPONENT” give a configuration name , say “ZDEMO_SUBSTEP_CONF” and click “Go to Component Configuration”.

Where to find FPM_GAF_COMPONENT???

[m_aravindan · Accepted solution]

Hi Kim ,

         Go to se 80 .  Just give webdynpro/interface ( which will be avaialble).

in the below field just give FPM_GAF_COMPONENT. CLICK on enter.

it will show a tray , in that click on webdynpro application. there you will finding your ZDEMO_SUBSTEP_CONF. Right click on it and choose create , it will take you to the step as shown in step 16.

regards

Arvnd

[Former Member · Accepted solution]

Hi Aravind

Thanks, thats correct. But do you mean Create or Create/Change Configuration?

Bst KIm

[Former Member · Accepted solution]

Hi Aravind

I now found back on track.

Thank you vm.

Brgds Kim

[Former Member · Accepted solution]

Hi Aravind

I still have a problem on step 19:

I cannot enter at Configuration Name in the Table as shown,

but below the table in Application Parameter settings I can enter Configuration Name,

But i cannot find step 20

and click “Go to: Component Configuration”.

Brgds Kim

[m_aravindan · Accepted solution]

Hi Kim,

              Enter a configuration name on step 19 as said , click on go to component configuration ,  will show an error , as it does not exsits. then click on create to create the configuration. then it will go to step 20.

Regards

Aravnd

[Former Member · Accepted solution]

Hi

Everythinks works fine now.

Thank you very much.

Brgds Kim

[RicardoRomero_1]

Hi Kim,

Check this link with some tutorials; Check the tutorials 5 and 6.

http://wiki.sdn.sap.com/wiki/display/WDABAP/eLearning+Tutorials+-+Floorplan+Manager+for+Web+Dynpro+A...

You need to create a componet configuration to add the Main steps and substeps.

Regards,