on 02-20-2007 1:32 PM
<b>i am sending idoc using program</b> - with function master dat distribute function,
now if i set SEND IDOC IMMEDIATELY in outbound message in we20 'partner profile' than idoc get status 03 but at reciver end idoc not found with any status.
if select collect idoc immideatly than work properly.
what precaution needed while sendig idoc throug send idoc immideatly with Program,
regards,
r p.
Hi,
Can you try deleting the idoc metadata for this message type in idx2 (in XI ) and then try resending this idoc
Regards,
Vikram
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
there is no error in sm58.
now what to do?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
where is start sub system option?
regards,
dushyant.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
i checkd there is packet size 1 only.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi rp,
when using SEND IDOC IMMEDIATELY in outbound messge, the packet size should be 1 and use start subsystem option.
Thanks,
Rajeev Gupta
Message was edited by:
RAJEEV GUPTA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi r.p.
did you check SM58?
Regards Mario
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.