Problem in calibration cycle for equipment

[Former Member]

Dear all,

For calibration of any test equipment

we have 4-inspection points, in which 4 samples  for each

Measured value, before adjustment, after adjustment, Correction factor

Out of these four values, only from after adjustment value needs to compare target value and error

Rest of the values needs for reporting purpose.

Example:

Equipment-Pressure gauge, range (0 to 16 kg/cm2)

Inspection point	Measured value	Before adjustment	Correction factor	After adjustment	Error in %
Calibration on 4 kg/cm2	4	3.8	1	4	0
Calibration on 8 kg/cm2	8	7.9	1	8	0
Calibration on 12 kg/cm2	12	12	1	12.1	1
Calibration on 16 kg/cm2	16	16	1	16	0

We want to create 4 MIC’s for each equipment in task list not more than that, and want to calculate error on % between after adjustment and target value only rest of the sample values only for calibration report.

Is there any solution regarding this.

Regards

Pradeep yadav

[former_member184536]

Dear Pradeep

Yes it is possible.

Create four MICs for

Chars 1)Meaured Value

          2) Before Adjustment

          3) After Adjustment

          4) Error.

Char "Error" must be calculted char whose valuse get calculated  acco. to your foumula.

Manish

[former_member662213]

Hi,

In my opinion, you have following two option:

1. Create a z-report where in you can calculate the error in % .

2. Use the BAdi (QE_SAVE), which is called at the time of saving of results wherein you can get an information about "error in %" for the MIC's and it can be stored in some z-table / standard table.

Regards,

Sumit