MOPZ - unable to generate stack to EHP5 implementation

[MichalSarna]

Hello,

I'm fighting with stack generation via MOPZ for ERP 6.0 EHP3 system on dual stack.

ABAP and JAVA are connected to SLD @ Solution Manager.

Entry about JAVA is looking good in SMSY, entry about ABAP also.

ABAP entry in SMSY ia assigned to products:

EHP3 FOR SAP ERP 6.0

SAP NETWEAVER 7.0

I want to upgrade to ERP 6.0 EHP5. I'm trying to generate stack and have following errors:

EHP Component IS-UT 602 without suitable Technical Usage!

EHP Component IS-OIL 602 without suitable Technical Usage!

EHP Component IS-M 602 without suitable Technical Usage!

EHP Component IS-H 602 without suitable Technical Usage!

EHP Component IS-CWM 602 without suitable Technical Usage!

EHP Component ESA ECC-SE 602 without suitable Technical Usage!

EHP Component ECC-DIMP 602 without suitable Technical Usage!

Any ideas?

Best Regards,

Michal Sarna

[Former Member · Accepted solution]

Hello!

First of all you will need to assign your system as SAP ERP 6.0 with logical component, because this is the appropriate product. Additional EHP components should also be assigned.

If you use some addons like IS-OIL, etc. you will need to assign these in SMSY/LMDB too.

[MichalSarna · Accepted solution]

Hello,

Yes, I have logical component SAP ERP6.0 assigned to solution. Without this I could not even start MOPZ for this system. In SMSY I also have assigned this system to product ERP 6.0.

[Former Member · Accepted solution]

Once again, if your system is SAP ERP, then is your assignment is wrong:

ABAP entry in SMSY ia assigned to products:

EHP3 FOR SAP ERP 6.0

SAP NETWEAVER 7.0

You have to assign you system

SAP ERP 6.0

EHP3 for SAP ERP 6.0

Then you should pay attention to these warning regarding the add-on components IS-UT 602, IS-OIL 602, etc.

If these add-ons were assigned within SMSY/LMDB and you do not need them, then you should delete the assignment.

Good luck!

[MichalSarna · Accepted solution]

Thank you very much. Stack generated:)