Inspection lot display

[former_member369043]

Hi All,

In the inspection plan there four MICs but from QA32-->Inspection lot-->Specification , the inspection plan group is showing two parameters in the same group (Plan).

1. In QP03 the four inspection charecteristics are displayed.

2. In inspection lot result Recording four charecteristics are displayed with measured values. But from Inspection lot(QA32) specification two charecteristics are displaying.

3. This two displayed inspection charecteristics are coming in the CoA output (QC22).

Is there any standard setting for this kind of various display in SAP?

Regards,

NKB

[Former Member]

There is huge possibility that these MIC's are appearing from "Material Specification" ,check QS63 t code for same material.