centrial contract replication to ecc error

[Former Member]

Dear expert,

Iam using SRM 7.0 EHP2, central contract fucntion. When distributing a central contract to ecc system (ecc 6.0 EHP6) using PI, I found an error in ecc using tcode SXMB_MONI: "Enter a unit of measure". Could anyone give some advice to help fix this issue?

Thanks very much and best regards.

Meng yang

[Former Member]

This issue has been fixed.  We need to map the srm to ecc conditon.

[kaus_desh]

Hello Yang

please let us knw in more detailed about solution what you mapped in SRM to ECC and where in which t code ??

kaustubh

[former_member183819]

Hi

Are you creating contracts for material or material group ?

please attach contract item data here . what is the UOM for material.

[Former Member]

Thanks for everyone's reply.  Our contract contains material, the UOM of the material is TO, the ISO code is maintained and is the same with ECC.   So you pls give more advise on this issue?

Meng yang

[former_member183819]

Hi

What is the equivalent UOM in english ?

What is the master data 3000000020  Basic UOM and Order unit UOM in ecc?

Is there any purchase order already exists for this material 3000000020

Note 1757826 - Frequency cusotmizing allows non-existing unit of measures?

[Former Member]

Dear govindasamy,

The English UOM is TO. For material 3000000020, its basis UOM  is TO, and no Order unit UOM. And  There is aleady PO exists for material 3000000020.

So could you pls share more information about it?

Thanks very much and best regards.

Meng yang

[Former Member]

If you have maintained UOM in SRM Central contract, check if the ISO code is maintained for the unit in CUNI and if it is the same in ECC.

Only the ISO code is sent in XML.

Regards,

Sushil.

[former_member208675]

Hi,

Enter unit of measure when you decide quantity. It will resolve this error.

& if not, you can also check available UOM in SRM. use Txn CUNI.

Regards,