on 09-15-2012 6:31 AM
Dear all,
Situaltion is as follows.
Result is being recorded for 3 samples - 5mm, 6mm & 7mm
Based on this result, valuation should be happen based on following formula - 6.5 >=(Average of (5+6+7)+0.25(Max 5mm, 6mm,7mm)-0.25(min 5mm,6mm,7mm)
For this I have maintained characteristics
L0 to capture results of 3 samples.
L1 a formula based caracteristics.
Quality plan is prepared & above characteristics are assigned with
Characteristics 0010 as L0
Characteristics 0020 as L1 with formula B00010+0.025*BA0010-0.0025*B90010
But while checking I am getting error message " The specified formula parameter for the characteristic requires partial samples"
Guide me how to resolve this error.
PKS.
Thank You. Checked. found OK.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please change all formula parameter "B" to "C".
C00010+0.025*CA0010-0.0025*C90010
The formula parameter "B" is normally used with inspection point functionality.
Regards, DoWook KIM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
11 | |
10 | |
6 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.