Prod Order Error - Fill in all required entry fields

[Former Member]

Dear Gurus

While converting PP/DS Planned Orders to Process Orders, we have recently started receiving the error 'Fill in all required entry fields' in the /sapapo/cq.

What could be the possible reasons?

Regards

Dilbagh

[Former Member · Accepted solution]

Hi Dilbagh,

Can you provide some more information?  It may help in narrowing down the problem.

What is your system and service pack level for both APO and ECC?

When did the symptom show up?  How recent is "recently"?

Did you make any changes to order type or other configuration?

Is it for all products or some specific products?

Could it be for products that have been recently integrated with APO?

Were there any changes to CIF configuration?

Is it happening for everyone or just one user? 

Was there any business process change?

Were there any changes to the PDS (or PPM) structure? (Alternate or parallel sequences for example)

Best Regards,

Mike

[Former Member · Accepted solution]

Hi Mike

Thanks for a prompt response

Here's the information in chronological order

1)

APO - SAP SCM 7.0

ECC - SAP ECC 6.0

2) We faced the issue for the first time on 8th Sept 12.

3) I need to check for the changes to order type.

4) It's for just 1 product

5) no

6) no

7) we have 3 users for PP/DS. any ID could have been used

😎 no

9) no

Regards

Dilbagh

[Former Member · Accepted solution]

Hi Dilbaugh,

Since the error is for only one product, the error points to a change in master data.  I can't guess what field you are missing.  Try to compare in detail the material master, product master, routing (or recipe) and PDS between a good product and the one you are having trouble with.

You may try to retransfer the PDS.

Best Regards,

Mike

[Former Member · Accepted solution]

Hi Mike

The issue was in the Order Type Configuration.

Thanks a lot.

Regards
Dilbagh

[rupesh_brahmankar3]

Dear,

I think this product may have activated for Repetitive Manufacturing. Kindly remove Repetitive mfg tick and REM profile from the MRP 4 view of material master and try the same.

Regards,

R..Brahmankar