cancel
Showing results for 
Search instead for 
Did you mean: 

Usage decision for inspection lot type 08

Former Member
0 Kudos

Hello colleagues.

We are performing QM checks on raw materials that we transfer from one plant to another.

This is inspection type 08 and the inspection plan usage is 09.

The point is that, after recording the results, when we go to usage decision, two selected sets appear for me, as you see below (RAW and SEFI).

Honestly, I was expecting only the RAW one.

Do you know where this kind of thing is set in QM ?

Regards,

Fernando Luz

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

Hi Luz..

Please assign selected set for inspection type '08'

svs_sap
Active Contributor
0 Kudos

Hi

Check selected set settings in QS52 transaction for UD for catalog 3 for inspection type 08.

Best regards,

Sharat

Former Member
0 Kudos

Hi,

Correct, assign the selected sets against 08 inspection type in SPRO.

Regards

Former Member
0 Kudos

It might be because ,

There are two plants for which you have created two corrosponding selected sets or there are two selected sets that you have created for same plant.

Now,In the config QCC3---.Inspection lot creation --->Maintain Inspection type-->08 inspection type.

Here enter selected set related to RAW one & tick on "Selected set in same plant" ( provided that you have created seleted set plant wise)