Unable to view SAPScript form in SE71

[Former Member]

Hi,

I have moved my SAPScript form from DEV to QAS and Production system. When I went to SE71 in QAS, it is showing that my form is available only in 000 but not in my target client - QAS 250. Similar to Production - only available in 000.

The versions of the transported form is same between DEV , QAS and PRD.

If you look at the attached screen, you can see that the first 2 forms are only in 000, and not in QAS250. However, the remaining forms are in both 000 and 250.

Is there any impact on the system since the forms are only in 000?

Thanks Gurus,

Intan Azir

[Former Member]

SAP scripts are client dependent and yet  I believe are part of repository (a bit of paradox actually) . Though it is repository object it can differ from one client to another. So make sure that ur transport has gone to the right client.

Check this out:

http://scn.sap.com/thread/508485

Regards.

Ruchit.

[Former Member]

Intan,

As Paul suggested, re-import the transport and select the target client as 250 and check again.

Thanks,
Arjun

[paul_power]

Hello Intan,

It should be possible to trasnport to the target client.

Were there any errors (or even warnings which may be relevant) in the transport export or import logs?

regards,

Paul

[Former Member]

Hi Paul,

If I don't, would there be any impact?there are actually a lot of forms that are only in 000.

[paul_power]

Hi Intan,

It would not be of harm, it just would not be available in client 250.

If you are okay with it being in client 000, then thats fine.

regards,

Paul

[Former Member]

Thanks Paul. Will relay the message to my abapers.