cancel
Showing results for 
Search instead for 
Did you mean: 

control chart for MIC

Former Member
0 Kudos

Dear all ,

i have maintained : MIC Quantitative as M1 in routing operation for 03 type of inspection .

MIC is having SPC, Sampling proc, upper , lower value , Single result recording , fixed scope etc .

Sampling procedure IP1 is fixed , spc criteria , with insp point , and control chart 111. , SPC criteria = MIC (060 ) , sample size = 5 .

Assignment is OK in routing operation . M1 is used in 3 materials A, B & C .

Now results have been recorded for inspection lots created for material A, B , C ( 3 times for each insp lot as insp point freely defined point and single 5 values as of sample size =5 ) .

Now i am using QGC3 for control chart for mic M1 , with plant , Status 1 ( tried 3 & 5 also ) .

but i am getting only one line line with only one inspection lot with other status i am getting message " no entries "

Pl guide where i am missing ?

Regards ,

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Try to change SPC criteria

if you want Lot wise  -  SPC criteria : "030"

if you want Material wise - SPC criteria : "070"

See the changes

Answers (0)