on 07-20-2012 3:20 AM
Hello
I am testing a small network, I had created Product P1, L1 at a main DC and two outer DC as L2 and L3. P1 is extended to all locations and T-Lanes created from L1 to L2 and L1 to L3. P1 is externally procured item at L1 while L2 and L3 have forecast. When I ran a ctm profile to roll-up the demand at L1. CTM
reads demand elements but not created supply elements like stock purchase requisitions at L2 and L3 and Purchase Requisitions at L1. What am I missing?
Interestingly, if I run Network hurisitic from planning book it created all respective supply elements.
Thanks,
Sam
Hi,
Could you please check the below points?
How did you check that CTM reads the demand elements?
Have checked the consistency of your master data selection?
Is your time stream is long enough to consider the demands?
When you run CTM, did you get any error or any other message?
Regards,
Manimaran M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.