on 07-19-2012 10:17 AM
Dear all,
can somebody help me? After installation of SP I get the following short dumps when I try to open
the workcenter "SAP Engagement and Service Delivery":
Category | ABAP Programming Error |
Runtime Errors | UNCAUGHT_EXCEPTION |
Except. | CX_WD_CONTROLLER_NOTEXIST |
Web Dynpro Component AGS_WORK_SERVICES_ENGAGE
ABAP Program | /1BCWDY/0O2SQHY4HWGQTACH68GI==CP |
Application Component SV-SMG-SVD
Date and Time | 19.07.2012 11:06:07 |
Error analysis
An exception occurred which is explained in detail below.
The exception, which is assigned to class 'CX_WD_CONTROLLER_NOTEXIST', was not
caught and
therefore caused a runtime error.
The reason for the exception is:
Controller VW_360_REVIEW Does Not Exist
Thanks in adance!
Kind regards,
Joern
Hi Saurabh,
thanks for the information. But both notes were outdated for my release. Do you have another idea?
Kind regards,
Joern
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Joern
Have patched your system to SP05 from older SP level, as you have mentioned:
"After installation of SP I get the following short dumps".
If yes, then have to performed solman_setup steps again.
These notes correspond you the error described by you. But these where in earlier releases but you can still check if it helps:
Note 1611200 - Service Delivery SP26~SP02: dump while maintaining old cycle
Note 1604370 - Service Delivery SP02: dump after pushing 'change' button
Mainly this, as this related to SP05 as well:
Note 1685463 - Cycle: Missing authority check for cycle creation button
Please let us know if any of these helps.
Best Regards
Saurabh
Fujitsu Consulting India-FCI
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Silambharasan,
it didn't help. I have still the short dumps. Do you have another idea?
Kind regards,
Joern
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Joern,
Can you check this also and revert back,
Note 1068384 - Runtime error CX_WD_CONTROLLER_NOTEXIST in Web Dynpro
Appreciate if it helps.
Hi Joern,
Check the note numbered - Note 1493174 - MOpz: exception CX_WD_CONTROLLER_NOTEXIST
This may help you. appreciate me if it helps.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
92 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.