on 07-10-2012 10:20 AM
I'm trying to set up a control type for VL02N, in wich to call a smartform I've developed but VL02N says the processing program is missing for that output type. I've done all the steps in NACE, setting the processing routines for the output type.
Has anyone had this problem?
Hi Fernando,
I'll just mention some steps I would check...
1. NACE: for the output type: program, form routine and form should be assigned.
2. Processing program: is the program active?
Which is the number of the error message you mention?
Regards,
Ornella
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The document type may be used in the access sequence of the output type.
The error message you mentioned has a combination of condition type, medium and application.
Is the correct output type being determined? (this may vary according to the document type).
Is the correct medium being determined? (this is set in the condition record),
User | Count |
---|---|
92 | |
11 | |
10 | |
6 | |
5 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.