Software component is not showing in the backend receiver system

[Former Member]

Hi Experts,

I am doing the scenario is IDoc to Proxy, I have impoted all the design time objects  from some other system, not created in my system.So my questiion is when I am logging with backend  receiver system by using tcode SPROXY , I am unble to get my Software compont in to backend rec.system,all the configurations are working fine. So what might be the problem. please  give the best suggestion.

Thanks in advance,

Sanjeev.

[marksmyth]

Hello Sanjeev,

Check if note #1528587 PI ESR Content 0bjects are not visible in SPROXY, matches your issue.

Regards

Mark

[former_member184681]

Hi Sanjeev,

You need to assign the new Software Component to your backend system in SLD. Once you do that, you should see the SWCV in SPROXY.

Regards,

Greg

[Former Member]

Hi Glowacki,

Thanks for the reply.

As of your advice once again I have configured all the software component to my backend system , but I am unable to get ESR objects in SPROXY tcode in  my backend system, what might be the problem .

Please give the valuable suggestion.

Thanks in advance,

Sanjeev.

[former_member184681]

Hi,

Have a look at this Wiki for a complete SPROXY preconfiguration. Make sure all the steps are properly configured in your system.

Regards,

Greg

[Former Member]

Hi Greg,

I think you have  forget to send the link.Please share the Wiki.

Regards,

Sanjeev.

[former_member184681]

Sorry, here is the link:

http://wiki.sdn.sap.com/wiki/pages/viewpage.action?pageId=72123509

Regards,

Greg