on 06-29-2012 5:46 PM
Hi Gang,
I need some help.
I have a test that is set to less than 100 ppm. How do I set that up in my Characteristic range? If I put it to upper limit as 100 than the spec shows <=100.. I don't want it to pass if it hits 100.
Please help!
Thanks so much
Hi Bruce,
Yes, its simple.
Put > 99 is ok. If value is 100, system will not pass it.
This fulfills your requirement.
Regards,
Srini
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Then you have to set the upper limit as 99. SAP is set to recognize <= not <.
There have been several previous discussions on this topic in the past. Please google.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.