06-23-2012 3:37 PM
Hi guys,
From the added picture you can see if the loss is greater than 3% of total LT metering consumption, the difference consumption will be distributed proportionately among the LT consumers.
Can it be done using Installation Group? If so please guide me through.
Thanks,
Arghya
06-26-2012 7:23 PM
Hi Arghya,
Yes you are right you need to setup the meters as installation groups.
You might need a custom variant for claculating the 3 % difference and also please look into variants UTILIT86 to UTILIT93 and see if they help.
thanks,
VR
06-26-2012 12:45 PM
06-26-2012 1:14 PM
Hi,
As per my knowledge you need to write a custom code.
May be the profiles in EDM ( Metering points scenario) will help you out. But I am not good enough to guide you on EDM.
Regards
Sachin
06-26-2012 3:10 PM
Hello Arghya,
Can you please illustrate what is the complete objective WITH your case and question?
SAP has several new means to build in extra complex Logic into EDM and Billing , but also
plain vanilla Functions doing recursive calcs and itabs can do the job.
kind regards,
robert ten bosch
06-26-2012 5:06 PM
Hi Arghya,
Create operands for the billing schema of main HT meter. These operands will give you the meter reading values for other submeters ( you may need to develop a small code for that ) and develop a variant program & logic for 3% loss distribution among other secondary devices.
Also pls make sure the ERCHV operand button is checked in EA50 as the same is used for data exchange between primary and secondary installations. Also for more details press F1 on ERCHV operand check button in create operand tcode ( EA50).
Hope this will give you a way ahead.
Regards
Girish
06-26-2012 7:23 PM
Hi Arghya,
Yes you are right you need to setup the meters as installation groups.
You might need a custom variant for claculating the 3 % difference and also please look into variants UTILIT86 to UTILIT93 and see if they help.
thanks,
VR