Problem while doing UD for inspection lot.

[former_member216607]

Dear SAP ,

     I am facing problem while doing UD for the inspection lot.I will first explain complete process to you.We create two client 200 & 300, On 200 only configuration should be done no master data So i created Catalog & Selected Set on 300 client.and configuration setting is transported from 200 client.Know what the problem i face is that , which doing UD after result recording it not show the catalog which i created on 300 client .But the same catalog is shown while i checked in QS41,for UD.What may be the issue , pls tell.Other catalog which i created  are ok, eg  1,9 .

Regards

Asif Saiyed

[former_member184536 · Accepted solution]

Hi Asif

There is difference between Code group (QS41) and Selected Set.(QS51). Code groups are at client level and selected set are at Plant level.

and Also check that in inspection type setting "Selected Set in same Plant is ticked or not".

Manish

[former_member216607 · Accepted solution]

Hi Manish,

           Thanks, Yes i able to do it, In inspection type setting the selected set ticked was not done.