on 06-21-2012 2:32 PM
HEllo QM Experts
I am trying to rlease a inspection lot generated automatically for inspection type 01 at the time of Goods receipt for PO
The status of Isnp lot is CRTD and so i cant reocrd the inspection result.
I went to QA02 and ofund status created. When i wnet to Assign TL/Material specifictaion below error shows
(For your info: material QM view has Ispction by Mtrl speciifcation and insp by task list acticvated.
Insp plan also created and MIC also assigne dto opeartions, )
I cant figure why this problem
Error details:
Task list could not be found although it was defined for this inspection
Message no. QA276
Diagnosis
The inspection setup for this material in the quality management view of
the material master defines an inspection with material specification
and task list. In this case, a material specification is available, but
a task list could not be found.
System Response
Sample calculation and inspection lot release are not possible without a
plan.
Procedure
Assign a task list retrospectively.
Murad
Please see this article by Anand Rao.
It should help you. Don't forget to rate the article!
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
7 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.