on 06-20-2012 1:19 PM
Hi,
Good morning.
We are planning to upgrade our SLL-NFE component SLL-NFE 1.0 to SLL-NFE 10. In our landscape SLL-NFE component is on our PI system (SAP NW 7.0). As per the documents in SDN and SAP Notes, we understood that we need to go for EHP2 upgrade of SAP NW 7.0 so that the SLL-NFE component will be upgraded to SLL-NFE 10. After that SLL-NFE 900 PI Content should be imported.
We are unable to find any documents or information related to post upgrade activities. Please provide some information related to the below queries.
1. Does the existing configurations of SLL-NFE component will be sufficient after the upgrade or do we need to perform the entire configuration of SLL-NFE again?
2. Does the PI content configurations to be done again after the upgrade?
3. Do we need to perform any configuration changes or apply any SAP Notes in SAP ECC (ECC 6.0) after the upgrade to SLL-NFE 10?
Please provide your expert inputs for the above queries.
Thanks
Nalini
Hi Nalini,
the SPED & NFe space is part of the Portuguese community space and hence only discussions in Portuguese are allowed.
Additionally, your questions were already responded to in order threads of the space (of course, they are in Portuguese). In short, yes, you do need to re-run the configuration wizards for PI, you have some additional configuration steps necessary to NFE 10 (i.e. config of certificate in ABAP layer, tx STRUST). For ERP, though, it should be transparent.
I'll lock this discussion thread now.
Best regards,
Henrique.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
13 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.