on 06-15-2012 2:43 PM
Dear friends I am getting the error in solution manager maintenance optimizer kindly give me suggestions.kindly find the attached doc file. for the error
below i mentioned the error
transaction must be assigned to standalone product version
please assign ER6.0 to maintenace optimizer transaction.
Hi Sai,
The system in transaction smsy must be defined only as ERP 6.0 and not as ERP 6 EHP "n" then assign it a logical component.
Best Regards.
Fernando.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
1702990 - Error Transaction must be assigned to a Standalone Product
1357565 - MOpz: Maintain a system where EHP is installed
1344564 - Maintenance Optimizer: Check system landscape
There are a few easily found documents about this.
Best regards,
Miguel Ariño
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Goto SMSY transaction and navigate to the respective product system under Landscape Components -> Product Systems. For the system, under Header Tab goto change mode and Product Version assignment. Here add SAP ERP 6.0 and save. Make sure a corresponding logical component is also created for this and used in the MOPZ transaction.
Regards,
Srikishan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sai Pankaj,
Can you attach the doc.file again as I don't think it has been attached.
Basically, you should create a mopz transaction for SAP ERP 6.0 and not for any other product.
Kind regards,
Roland
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.