Sender File to Receiver AS2 Filename

[former_member190358]

Hi Guys,

I have File -> AS2 scenario. I want to have the file name on the AS2 receiver same as sender File adapter.

As suggestd in one of the topics of forum i have used the attribute mapper module to map the sender file name

and done the following changes in SEnder and received side :

1. set the ASMA in the sender channel

2. check dynamic attributes in the receiver AS2 adapter and check the file name

3. use Attribute Mapper in the module tab

4.  Map the received file name to the dtAS2 file name is the configuration .

But still the file name is not appearing at the receiver side .

Please help with your suggestions.

Regards,
Ravi

[Former Member]

pls refer below Blogs:

http://scn.sap.com/thread/1593736

http://scn.sap.com/thread/1655724

[zameerf]

Hi Ravi,

Did you check the audit log of the AS2 receiver? Is there any info on the module being called?

What is the Parameter name and value you have mentioned for the AttributeMapper module?

Please refer the below thread as well if you haven't checked yet.

http://scn.sap.com/thread/1860795