on 05-27-2012 5:13 AM
Dear All
I m creating a manual inspection lot with origin 89 by BDC.but i m receiving this error No batch input data for screen SAPLQPL1 0200,please confirm where i going wrong my MIC are reference characteristic
Regards
Have you entered number of containers ( & if its actually not supported) ? then system can show such problem.
Best way to deal with such issue is to rn the prog in foreground and then check.check individual tabs like "Inspection specification" ,"sample" etc
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
The reason for this popup error could be:
While creating manual inspection lots - you will have to specify the
inspection type also - this is mandatory. The specified inspection type
(which you give during manual lot creation) should also be maintained in the
material master. The pop up message that you have mentioned is the one which
proposes the inspection type I believe.
This can also be configured in your BDC programme i.e., if you have only
one inspection type for creating manual inspection lots for all materials
then the same can be configured in the programme - otherwise it should be
mentioned in the data sheet which u use for uploading.
Hope this helps you
regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.