on 05-25-2012 7:48 PM
Manual pricing condition is not getting applied. We have a manual pricing condition that is being applied to multiple pricing procedures. All other pricing procedures works fine but there is one procedure where this manual condition type is being used and when you put in a value it does apply it. The value just disappers. I have checked the settings of this manual pricing condition in all procedures and they are all identical. any help?
Hi ,
Check the "Requirement routine" for this Manual pricing condition in the Pricing Procedure.
See if there is some condition that is being checked to Trigger the Pricing condition.If it's not being satisfied then the Pricing condition would not appear in the Document.
In case of any further queries/clarifications,please revert.
Please Text Removed,if the solution fulfills your request.
Thanks and Regards,
Umesh Karane.
Message was edited by: G Lakshmipathi
Please dont add such comment and deviate the forum rules.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Update here what is the message system is showing in Analysis tab.
G. Lakshmipathi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.