MIGRATION CLASSIC to FLEX

[Former Member]

Hi Experts,

I'm working in a Migration project of CL to FX.

On step 9  i received the message bellow :

"No reference flow type for object transfer was assigned for 999 999

Message no. REMICL058"

i was receiving this message for each condition, and it was solved

including the respective customizing, but this message continue stopping

my progress.

Thank's for share any experience about this problem,

[bowen_cao · Accepted solution]

Hi,

The issue should be due to the following entries in table TIVCDCONDTYPE.

Please check the table accordingly:

MANDT CONDTYPE CONDPROP FLOWTYPE CALCRULEEXT

030   0009              999                             <<<<
030   0999              0999

There is an entry with FLOWTYPE 999 without leading zero which
normally should not occur.

I would kindly ask you to change the flowtype for condition 0009

in table TIVCDCONDTYPE from 999 to 0999 and check afterwards

if the issue is resolved.

Regards, Bowen

[Former Member · Accepted solution]

Thanks a lot MR Bowen.

[Former Member]

Hi there,

I am not too sure about your issue but you may want to try the following:

1) Check your Flow Type(trace from Condition Type back to Flow Type) from your upload data in the source file and make sure all the flow types exist in Define Flow Types and Assign Ref. FT(look for it under Condition and Flows in IMG)

2) Maybe you can pay particular attention to Assignment of Reference Flow Types

     i) Check if you have a relation 30 Distribution Posting> for your transfer object. If you are not too sure what is transfer object, maybe try to look for Flow Type Name like Trsfr.

Try it! Hope it will help.

By the way, you mentioned Step 9, is it under LSMW>Read Data.

wcKon

[Former Member]

Dear MR Kon,

Thanks for your reply.

I checked my customizing and confirmed that all entries have the type of flow that have been criticized.

You know the technical names of these tables so I can check what else can be?

[Former Member]

Hi Danilo,

Sorry, I do not know the technical names. I have another suggestion for you which you may want to try as below:

1) Check in IMG>Accounting>Account Determination>Replace Account Symbols. Check if you have all the GL Accounts specified there are correct. It has to be in the GL Chart of Accounts.