on 04-27-2012 9:55 AM
Hello,
I have the following problem on a solman 7.1 SP04 in the system preparation steps.
I've searched SMP & SCN but I did not find any usefull info
I've an OSS message open on that point since almost a month !
The customer is trying to put some pressure on SAP support but I did not get any answer yet.
I get an error at step 6.3
SOAP:1.007 SRT: Unsupported xstream found: ("HTTP Code 404 : Not Found")
Web service invocation problem on host fr-erps01.knet.intra and port
8000 protocol : http logical port name : LP_WS_SMDAGENT_MONITORING
I did not get any error in all the previous steps (step 5.3 logical port creation did run without problem).
I've checked in SOAMANAGER and the port is not there.
Idid perform the check from OSS note 1659135 Web service invocation problem on the Solman 7.1
but I fail pinging Web services associated with consumer proxy CO_E2E_MAI_CONFIGURATION.
The errror is :
Web service ping failed (RC=404). Service Ping ERROR: Not Found
The customer will just use solution manager to perform Early Watch alert and Maintenance Optimizer Session.
Can I skip configuration step 6.3 and jump directly to "Basic Configuration steps" ?
Thanks in advance for your help !
Hi,
Please apply solution from 1663549 - Unsupported XStream found error to see if this helps.
Kind regards,
Roland
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
It was not deployed at all, I did had some problems with diagnostic agent installation when running sapinst.
I did provide a patch for DAA that was not appropriate and there was not other way than canceling DAA installation. I think this is why the services were not deployed.
I did get the SCA files, copy to \EPS\in and select "new software comp" in JSPM.
After this I had to manually reinstall the diagnostic agent (see OSS note 1234297)
Regards
Yves
You can find my post in SCN and the solution.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear all
Could you please send me the solution about this problem?
I've got the same problem in my solution manager and I don't find any solution on the SAP Marketplace.
Could you also tell me which SCA file do you haven installed?
You told: "I did get the SCA files, copy to \EPS\in and select "new software comp" in JSPM."
Please give me a feedback.
Thanks a lot.
Best regards
Tom
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.