display Unit in SNP Interactive planning table

[former_member245036]

Dear SAP,

I have a problem in display unit of product in snp interactive planning table.

In Planning Area for snp i setup unit is 'TỜ' when access snp table like this:

  1. Setup Planning area screen

       

2. Load data in interactive planning table in total level

         

3. Load data in detail level

    

As you can see Unit in step 2 is different with the 3 step and unit in the planning area

please explain and help us

thanks so much

hungth

[rajkj · Accepted solution]

Hi Hungth,

When you use the SNP data view at aggregated level (with multiple products loaded), the unit of measure UoM is defaulted to that of planning area. However, when you use the view at detailed level, the display shows the base unit of measure of the product.

Please check the base unit of measure of your product using t.code /sapapo/mat1 (tab unit of measure) and update the unit of measures appropriately.

Thanks,
Rajesh

[former_member245036 · Accepted solution]

Dear Rajesh,

in Product master tab Unit of measure i maintained 1 TO = 1 TỜ

it means that TO equal to TỜ

[rajkj · Accepted solution]

So, the base unit of measure for your product is TO. But, you wish to display the product in another unit of measure i.e. TỜ.

1. If possible, change the base unit of measure to TỜ

2. Otherwise, the second option is to maintain user settings to set the UoM as TỜ

Note: The user preferred unit of measure must be defined in product master record as you mentioned in your response i.e. in Product master tab Unit of measure i maintained 1 TO = 1 TỜ