cancel
Showing results for 
Search instead for 
Did you mean: 

No mobile asset management scenario exists for user xxxxxx?

Former Member
0 Kudos

Hi we are getting this for MAM.

The scenario and user exist and both R3 and Middleware are setup properly.

Thanks

Accepted Solutions (0)

Answers (5)

Answers (5)

Former Member
0 Kudos

The RFC connection wasnt properly setup both ways.

Former Member
0 Kudos

Ok so here is where the problem lies,

in merep207 the 090 objects do not have the specific user even though its is rightly created in R3.

Why would repliction not copy ALL users from R3.

THanks

former_member304703
Contributor
0 Kudos

Hi Ezatullah,

Try to run MAMXX_090_getdetail for each user which is returned by MAMXX_090_getlist. One of them is returning error and it breaks replication. I have seen this problem a few times.

Cheers,

Larissa

former_member304703
Contributor
0 Kudos

Hi,

this is what I would do:

1. Backend -> se37

a. execute MAMXX_095_getlist and then MAMXX_095_getdetail to see that scenario does indeed exist and there is no errors returned.

b. execute MAMXX_090_getlist and getDetails to check for similar information about the user, exist, no errors.

If previous all works go to the middleware:

Both 090 and 095 are "Timed 2-Way" syncBos and have to be replicated. Replicate them again and be sure it ends successfully. To be 100% on a safe side check tables on the middleware to see that your scenario is in MW DB.

Sync again. You should see in a monitor these customizing data sent to the device.

Cheers

Former Member
0 Kudos

Hello,

To complete Larissa: table is MEREP_207 and you should look for TOP struct ID. Also make sure the synchronization is completed (using transcation MEREP_MON).

Julien.

Former Member
0 Kudos

Hi,

You need to replicate the T01/T51 syncBos, and then sync the MI client. We had this problem and we had to sync several times before we could get the data.

Regards,

Rahul

AjithC
Employee
Employee
0 Kudos

The user is not configured to use the MAM in the R3. Configure the user dependent data in the R3 for the user. Transaction SPRO, under Mobile Asset Management -> Configure User Dependent data..

Please look in to the MAM customizing document for more details.The document is available in service market place.

Regards

Ajith Chandran