cancel
Showing results for 
Search instead for 
Did you mean: 

SFDC Integration

Former Member
0 Kudos

    Hi All,

I was able to do a sucessfull POC for create with successfull response from SFDC

Now when I am triggering the real data using Async scenario with custom SFDC WSDL I am getting HTTP 500 Error

When I copy and paste the same payload in SAOP UI and trigger it I get the sucessfull response in SOAP UI

Any suggestions are appreciated

Thank you

Sudheer

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi,

Check the request format (message structure) that XI/ PI is sending to the Legacy System and also verify the Target URL in SOAP channel.

For more information check point6 of this blog: /people/shabarish.vijayakumar/blog/2008/01/08/troubleshooting--rfc-and-soap-scenarios-updated-on-20042009

regards,

ganesh.

rajasekhar_reddy14
Active Contributor
0 Kudos

Hi Suudheer,

Run iunterface end to end and make sure that all your service interfaces are created as a sync mode.

Regards,

Raj