on 04-04-2012 11:02 AM
Hello everyone,
I have put dynamically the Target Directory and the File Name by using UDF in mapping with Dynamic Configuration, and it works fine.
Is it also possible to make a similar UDF for IP adress for the server ?
Thanks a lot.
JC
Hi,
>>>Is it also possible to make a similar UDF for IP adress for the server ?
no, this is not possible
Regards,
Michal Krawczyk
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Jean-Claude,
I believe you can achieve the same with a little workaround, assuming that you know the expected IP addresses in advance, and there are not too many of them. Simply create multiple, dummy receiver systems and one receiver communication channel for each receiver system, then route the message to the right receiver system (and therefore also receiver CC) in the Receiver Determination.
Hope this helps,
Greg
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Michal,
Thanks for your answer.
Regards.
JC
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
9 | |
8 | |
6 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.