on 03-15-2012 11:09 AM
Hello, I have only a small problem: In the bucket of a planning book the value zero and an empty bucket are the same. If I want to insert the value 'zero' in the bucket, the value disappears immediately. Is there a setting where I can make the value 'zero' visible in a planning book?
Thanks for your help!
Kind regards
Heinz
Hello, this functionality is available from SCM5.0, by setting 'Zero Allowed' flag for the key figure in planning area definition /sapapo/msdp_admin. Please refer to the online help http://help.sap.com/saphelp_scm70/helpdata/EN/59/e51d426fe35233e10000000a155106/frameset.htm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Heinz,
Go to your planning area in /sapapo/msdp_admin.
Click on Key figures tab, and then the "details" button.
Against the Key Figure, you would need to tick the box "Zero Allowed". Then system would differentitate between zero and initial (blank) value .
PS: You should be able to go to change mode through Extras->Key Figure Settings when you are in change mode for your planning area in /sapapo/msdp_admin.
Thanks - Pawan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.