cancel
Showing results for 
Search instead for 
Did you mean: 

How to remove Mass negative stock from Interim Storage 914

Former Member
0 Kudos

Hi,

There is a mass of negative stock in Interim storage type 914 after good issue.

So is there any easy method rather than doing it using LT01 ?

Your direction will be highly appreciated.

Regards,

Rock

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi

If the process is followed correctly there should not be a negative, the stock is posted from 914 but when you 'pick' the stock it should go TO 914 and so one cancels out the other

I hope that this helps

Frenchy

Former Member
0 Kudos

Hi Frenchy,

So to get corrected the customization so that there should no -ve quant in Interim Storage Type

914 .What & where we need to do more customization??

Regards,

Rock

Former Member
0 Kudos

Hi

It is difficult to tell without seeing the system!!

There should be a requirement to put stock in to 914 to balance out the negative

Frenchy

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi

Check LB10 to see if there is a Transfer requirement that needs to be processed to 'pick' the stock and move it in to 914 to remove the negatives.

Something must have triggered the negatives, It could be an issue against a production order ?

This will consume the stock from an interim st type but if the stock is not there it will create the negatives.

If this is the case then there should be a TR and then you create a TO and when confirmed it will send the stock to 914 and clear the negatives

If you want a transaction to clear them on mass then LT10 will work but really you should find the cause and 'fix' it with the correct process

I hope that this helps

Frenchy

Former Member
0 Kudos

Hi Rock,

-ve stock is allowed in interim storage type. If you wish not to have -ve stock in interim you may deactivate the settings at storag type.

SPRO>LE>WM>Master Data > Storage type

Well , first you see the total stock for each material (for which -ve stock exists) at WM as well as at IM level. Compare both the stock , it should match in that case you can move +ve stock to -ve & knock-off that entry , if not you need to move the stock to differences i.e.to storage type 999.

Afterwards try to analyse why & how -ve stock is getting generated. May be you can post your observation & you will get an answer for correction.

Thanks,

Mahesh